Metal Fence Angles

We do not make radius (curved) fence panels; that would be custom fabrication. However, if you’re handy, you can make lots of angles and curved barriers with our aluminum fence panels via one of the following two options:

OPTION 1: SLIGHT ANGLES

using line posts, corner posts or end posts (no mounts)

Insert the (fence panel) horizontal rails into the routed holes in our line post, corner posts or end post like you would during a typical installation. However, BEFORE you “set” the panel-to-post connection (with self tapping screws included with your purchase), you will simply turn the fence panel (left or right) up to 8 – 10 degrees. This procedure can be done with BOTH fence panels on each side of a line post or corner post if needed to give you 2X the 8 – 10 degrees. You can optionally cut a fence panel in half, on-site) and purchase an additional post to make additional angular fence-panel-to-post slight angles.

OPTION 2: HARD ANGLES

HARD ANGLES using Blank Posts + horizontal swivel mounts

For harder angles, like 30 degree, 35 degree, 40 degree and 45 degree angles, you will MOUNT two fence panels to one blank post using our horizontal swivel mounts. This method is more expensive (i.e. you must purchase 2 sets of mounts for each hard angle) but is the safest method because it allows you to make, on-site, any degree angle you need. When in doubt, use Option 2.